ControllerCheckup

Racing wheel test

  • PC & other
  • USB or Bluetooth
  • Chrome, Edge, Firefox, Safari
  • Nothing to install

Test a racing wheel and pedals in your browser: steering from lock to lock, throttle, brake and clutch travel, paddle shifters, the H-shifter and every button.

No racing wheel found yet. Connect it, then press any button.

Steering

Position
0%
Leftmost
–
Rightmost
–

Turn the wheel lock to lock. The marker should follow smoothly, without jumps, and come back to the top when centred.

Pedals and other axes

Press each pedal slowly to the floor. Each bar should rise smoothly from 0% to 100%. A bar that never reaches 100% may need calibrating in the wheel's own software.

Buttons

Press any button

Force feedback and rumble

Vibration needs Chrome, Edge or Opera, and a controller that reports its motors to the browser.

Every axis

Raw values from -1 to 1. A resting stick should sit close to 0.

Controller details

Name
–
Button names
–
Layout
–
Buttons / axes
–
USB IDs
–
Updates seen
–

Checklist 0 buttons tested

Waiting for your racing wheel

  1. Connect your racing wheel with a USB cable, or pair it over Bluetooth in your computer's or phone's settings.
  2. Press any button on it. Browsers only show a controller to a page after a button press.
  3. Nothing happens? Try another USB cable (some only charge), or open this page in Chrome or Edge.

How to test a racing wheel

  1. Connect the wheel by USB, let it finish its start-up calibration (it may spin), then press any button.
  2. Turn the wheel slowly from full left to full right. The marker should follow smoothly, without jumps, and return to the top when centred.
  3. Press each pedal slowly to the floor. Its bar should rise smoothly to 100% and drop back to 0% when released.
  4. Click both paddle shifters, run through every gear on the shifter, and press every button until the checklist is complete.

What to look for

ProblemWhat to do
Steering doesn't reach 100% in both directionsRecalibrate in the wheel's own software (Logitech G HUB, Thrustmaster Control Panel, Fanatec Control Panel)
A pedal stops short of 100%Calibrate it in the wheel's software; check the pedal's sensor and cable
A pedal bar flickers at restA dirty or worn pedal sensor. Add a small deadzone in your game
Wheel off-centreRecalibrate, or set centre in the wheel's software

Pedal bars are scaled to the range seen while you test. Press each pedal fully at least once for an accurate reading.

Force feedback

Browsers can't send force feedback to wheels, so it can't be tested here. Use the test in your wheel's own software, or a game.

Questions

Which wheels work?

Any USB wheel your computer recognises: Logitech G29, G920, G923, Pro; Thrustmaster T150, T300, T248, TMX; Fanatec; Moza and others.

Why are my pedals listed as "Axis 1, 2, 3"?

Wheels use a non-standard layout, so the browser numbers the axes. Press each pedal to see which number is which.

Can I test force feedback?

Not in a browser. Use your wheel's software or a game.

My pedals read backwards. Is that a fault?

No. Some pedals report 1 when released and -1 when pressed. The bars here are measured from wherever the pedal rests.

Does this work with PlayStation or Xbox wheels on PC?

Yes. Wheels made for consoles almost always work on PC too.