How to test your speakers
- Turn your volume down, then press Left. You should hear the sound only from the left speaker or left ear.
- Press Right, then Both. With both, the sound should seem to come from the middle.
- Run the full sweep. The pitch rises from a deep 20 Hz rumble to a 20 kHz whistle. Listen for buzzing, rattling or crackling.
- Sit centred between your speakers and try the phase check.
To test a particular device, such as a PULSE Elite headset on its PlayStation Link adapter, a soundbar or headphones plugged into your DualSense, press Show all outputs and pick it from the list. Your browser asks for microphone permission once, only so it can show device names; nothing is recorded.
What your results mean
| What you hear | Likely cause | What to try |
|---|---|---|
| Left plays on the right | Speakers or headset the wrong way round | Swap the speaker plugs, or turn the headset round (L on your left ear). |
| Both buttons sound the same, from both sides | Mono audio is turned on | Turn off mono audio in your computer's or phone's accessibility settings. |
| One side is quiet | Balance setting, loose plug or a worn driver | Check the balance slider in sound settings and reseat the cable. If it stays quiet, the speaker or headset side is failing. |
| Buzz or rattle at one point in the sweep | Something loose, or a damaged speaker cone | Note the frequency, then check for loose screws, grilles or objects resting on the speaker. |
| Nothing below about 100 Hz | Small speakers can't play deep bass | Normal for laptops, TVs and phones. Use headphones or a subwoofer for deep bass. |
| Nothing above 14–17 kHz | Usually your hearing, not the speaker | Most adults stop hearing very high pitches somewhere in this range. That's normal. |
The frequency sweep
Human hearing covers roughly 20 Hz to 20 kHz. The full sweep glides through that whole range in 24 seconds. The bass sweep (20 to 200 Hz) is good for checking a subwoofer or a headset's bass, and the high sweep (8 to 20 kHz) for tweeters and treble. Press Mark this point when the sound fades out or starts to distort, and the page tells you the frequency.
The phase check
Each speaker has a positive and a negative wire. If one speaker is wired the other way round, the two speakers push and pull against each other, and bass and voices sound thin and hard to place. In phase plays the same sound in both speakers: it should sound solid and centred. Out of phase flips one side on purpose, so you can hear the difference: it sounds hollow and spread out. If the in-phase sound is the hollow one, swap the two wires on one speaker.
Testing PS5 audio gear
For a full check of a PlayStation headset, including its microphone, use the PS5 headset test. To check 3D audio, try the 3D audio test, and for a home cinema setup, the 5.1 and 7.1 surround sound test.
Questions
How do I test my left and right speakers?
Press Left, then Right. Each sound should come only from that side. If they play from the wrong side, your speakers or headset are swapped.
Why do I hear the left sound in both ears?
Mono audio is probably turned on. It mixes both channels together. Turn it off in your computer's or phone's accessibility settings.
Can I test my PS5 headset here?
Yes. Connect a PULSE Elite or PULSE Explore through its PlayStation Link adapter, or a PULSE 3D through its USB adapter, then press Show all outputs and pick it.
Is it safe for my speakers?
Yes, at normal volume. Start low, especially with the bass sweep and the highest tones, and turn up slowly.
Why can't I hear the highest tones?
Hearing at the very top of the range fades with age, so most adults don't hear 17 kHz or above. That's normal and doesn't mean your speakers are faulty.
Does this record anything?
No. The speaker test only plays sound. If you allow microphone access to see device names, the microphone is closed straight away.