ControllerCheckup

5.1 and 7.1 surround sound test

Play a sound through each speaker of your home cinema system in turn, and check every one is connected, in the right place and about as loud as the others.

Where the sound goes

Pick your surround receiver, soundbar or HDMI output. Your computer must be set to 5.1 or 7.1 speakers for each channel to play on its own.

Speaker layout

Checking how many channels your browser can send…

Press a speaker to hear it

You

What to listen for

  • Each sound comes from the speaker that lights up, and only that one.
  • The subwoofer (LFE) plays a low hum, not a chime.
  • All speakers sound about equally loud from where you sit.

How to test surround sound

  1. Connect your computer to your receiver, soundbar or TV by HDMI or a surround-capable USB device.
  2. Set your computer to the right speaker setup. On Windows: Sound settings, your device, then Configure and pick 5.1 or 7.1. On a Mac: Audio MIDI Setup, your device, Configure Speakers.
  3. Choose your layout on this page. It tells you how many channels your browser can send.
  4. Press each speaker on the drawing, or Play each speaker in turn, and check the sound comes from the speaker that lights up.

Speaker positions

SpeakerWhere it goes5.17.1
Front left and rightEither side of the screenYesYes
CentreAbove or below the screen; carries most dialogueYesYes
Subwoofer (LFE)On the floor, often near the frontYesYes
Surround left and rightBeside or slightly behind youYesSide
Rear left and rightBehind youNoYes

The subwoofer plays a low 60 Hz hum rather than a chime, because it only handles deep bass.

If a speaker is wrong

  • Sound comes from the wrong speaker: swap the cables at the receiver, or check the speaker assignment in its setup menu.
  • A speaker stays silent: check its cable, that it's switched on in the receiver's speaker setup, and that your computer is set to enough channels.
  • Only the front two work: your computer is sending stereo. Change its speaker setup to 5.1 or 7.1 and reload this page.
  • One speaker is much louder: adjust its level in the receiver's speaker settings, or run its automatic room setup.

Surround sound on PS5

On PS5, go to Settings, Sound, Audio Output. Set Output Device to your HDMI device, choose the number of speaker channels, and pick an Audio Format (Priority): Linear PCM works with most receivers, or choose Bitstream (Dolby or DTS) if your receiver decodes it. Some soundbars and receivers also offer a built-in speaker test in their own menus.

Using headphones instead? Try the 3D audio test.

Questions

Why does it say my browser can only send 2 channels?

Your computer is set to stereo for that output. Change its speaker setup to 5.1 or 7.1, then reload the page.

Which channel order does this test use?

The standard order used by computers and HDMI receivers: front left, front right, centre, subwoofer, then surround (and rear for 7.1).

Why does the subwoofer play a hum instead of a chime?

Subwoofers only play low frequencies, so a chime would be silent. The 60 Hz hum is in the range every subwoofer covers.

Can I test a soundbar?

Yes, if it accepts 5.1 or 7.1 from your computer. Virtual surround soundbars spread the sound with processing, so positions sound less exact than real speakers.

Does it work with Dolby Atmos height speakers?

Not yet. Browsers can send up to 8 channels, which covers 7.1 but not height channels.