ControllerCheckup

Controller deadzone test

  • Diagnostics
  • USB or Bluetooth
  • Chrome, Edge, Firefox, Safari
  • Nothing to install

Measure the smallest deadzone that hides your stick drift, and the outer deadzone that lets every direction reach full speed. Then preview both live, before you change a single game setting.

No controller found yet. Connect it, then press any button.

Left stick

Raw
0.0%
After deadzone
0.0%
Furthest reach
–

Right stick

Raw
0.0%
After deadzone
0.0%
Furthest reach
–

Measure and preview

Press Measure, take your hands off the sticks for 3 seconds, then roll both sticks round the edge.

Suggested inner deadzone
–
Suggested outer deadzone
–

Amber circle: inner deadzone (ignored). Dashed red ring: where full speed starts. The dot shows what a game would see.

Waiting for your controller

  1. Connect your controller with a USB cable, or pair it over Bluetooth in your computer's or phone's settings.
  2. Press any button on it. Browsers only show a controller to a page after a button press.
  3. Nothing happens? Try another USB cable (some only charge), or open this page in Chrome or Edge.

What a deadzone is

A deadzone is a small area around the centre of a stick where the game ignores movement. It hides drift, so your aim doesn't wander when you let go. Too small and the drift shows; too big and small aiming movements disappear.

An outer deadzone works at the edge: it treats the last few percent of travel as full movement. If your stick can't quite reach the edge in some directions, an outer deadzone makes sure you still get full speed.

How to measure yours

  1. Connect your controller and press any button.
  2. Press Measure my deadzones and take your hands off the sticks for 3 seconds.
  3. Roll both sticks slowly round the edge a few times.
  4. Read the suggested inner and outer deadzones. The sliders move to them, so you can see the effect.

How to read the picture

ShapeMeaning
Amber circle in the middleThe inner deadzone: movement inside it is ignored
Dashed red ringWhere the outer deadzone starts: anything beyond counts as 100%
Blue dotWhat a game would see after both deadzones

Using the numbers in games

Most shooters and racing games have a deadzone setting for each stick, often under Controller or Advanced settings. Set it to the suggested inner value, or the closest step above it. If a game only has one setting for both sticks, use the larger number. For game-by-game advice, see the deadzone calculator.

Questions

What deadzone should I use?

The smallest one that stops drift: the suggested inner value from this test. Lower feels more responsive; only go higher if your aim still drifts.

What is an outer deadzone?

A setting that treats the outer edge of the stick as full movement, so worn sticks still reach full speed in every direction.

Is a 0% deadzone better?

Only if your sticks have no drift at all. Most controllers need at least a few percent.

Does this change my controller?

No. It only measures and previews. Change the deadzone in your game's settings.

Why is my suggested deadzone so high?

Your stick sits well off centre at rest. Run the stick drift test, and consider calibration or repair.